Quality-Built Supreme Starters are 100 percent new from the armatures, shift levers, brushes and bearings, drives and gears to the housing and casing, brush and brush holders. Even the permanent magnet and field coils are 100 percent new. It doesn't stop there. The commutator end covers, hardware and through-bolts, solenoids, caps and contacts are all 100 percent new. Quality-Built Supreme units are 100 percent new for unsurpassed quality.
I have a dead battery. Try to help launch the truck without success. I had the power of sound to all my accessories and the starter is not strong and slow when I tried to start the engine. So what's the problem? My truck is 10 years old and like all machines that I have a corrosion problem, you know, that fluffy white stuff around the battery terminals. Mine had gotten so bad I had to replace on a bracket on the cable itself six months, but I still had a lot of corrosion on the cable. TheCorrosion is a ground wire from the contact and "termination of the circuit", which is required to start the engine and the battery while the vehicle stops. Here is a temporarily work around out of trouble in order to save themselves. Please note: The battery is good. Liquid inside it with the right level. This is not a long term solution, because the battery is not charged. I used jumper cables, only the negative side to complete the circuit to a new ground point. A thick cablenecessary to enable them to meet safely. After the vehicle is started, remove the cable from the disk.