Monday, 7 November 2011

Tomb Raider lll - RX - Tech Mines walkthrough (part 3 of 3)

Tomb Raider lll - RX - Tech Mines walkthrough (part 3 of 3) On YouTube.





UPPER LEVEL MINE CAR: Before heading out, use your crowbar to open the door at the end of the walkway near where you entered. Inside you'll find a LEAD ACID BATTERY. And, if you didn't do it earlier, return to SECRET AREA #1. If you followed the walkthrough for the middle level, the inner door will be open. This is SECRET #2. There's a mutant inside, along with a save/power-up crystal, MP5 and Desert Eagle clips. Climb back out the way you came and safety-drop to the ground. Now head up to the upper level mine car. Ride the mine car up a hill and down the other side. Don't brake for the curve or you won't be able to get up enough speed to jump the gap. Duck under the girders and drills. Continue into a cave where the car will stop. Pick up the flares on the snowbank ahead to the left. Jump over to the WINCH. Place the battery in the opening on the side. Climb onto the top platform (facing the arm) and use the winch starter to get it going. This will lower the yellow submersible. Now comes the hard part. In the pool below the winch platform, there's a single yellow light on the wall. Dive in and swim down toward that light and into the passageway just to the right of it. You can climb out here to get air and warm up. Now, jump in the water again and swim underneath the submersible where you'll find an opening you can climb into. There's a large medipak inside. Now you're aiming for a small opening between the two lights on the wall below the sub. Swim through that opening ...

Tags: Tech, Mines, Part

indoor kerosene heater

Saturday, 5 November 2011

Starter BMX ramp

Starter BMX ramp Video Clips.





Putting a new BMX through it's paces, a novice starts jumpin!

Keywords: BMX, novice, jump, ramps, bike, bicycle

nikon camera tripods

Wagan Tech 4-in-1 Xtreme Power Review - etrailer.com

Wagan Tech 4-in-1 Xtreme Power Review - etrailer.com On YouTube.





www.etrailer.com Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information. Today we are going to cover part number WC02051 from Wagan Tech. This is their 4-in-1 Xtreme Power. This is a great device to have in your emergency kit in your car, simply because it comes standard with an air compressor and also a jump start feature. We will cover some more of the features in depth here. This provides 400 cranking amps of electricity to start your dead battery. It comes with industrial-quality, 4-gauge cables with heavy-duty clamps. And the next part we will talk about is the air compressor. It provides up to 275 psi of high-powered air pressure. It has a quick flow rate that can inflate a 16-inch tire in up to 5 or 7 minutes. It does come with a 1-1/2 foot, high-pressure air hose with quick-release valve connector, and it also comes with little adapters for it, too. It comes with a nozzle for inflating air beds or water toys. It has a needle adapter for sports equipment like soccer balls. And also there is a little adapter for bicycle tires. If you have Presta-type tube on your bicycle you have an adapter where you can use this where it converts it to a Schrader type and you can use the air compressor on that to fill up your tires. And the third feature is a detachable DC-to-AC power inverter, and this provides 150 watts of continuous power and up to intermittent 500-watt peak surge power. It includes one grounded AC ...

Tags: etrailer.com, 02051, wc02051, wagen, tech, four, one, xtreme, extreme, power, emergency, supply, kit, battery, air, compressor, inverter, AC, DC, auto, jump, starter

nesco pressure cooker Pb Kids Bedding

Thursday, 3 November 2011

Starting a Car With Jumper Cables - A Step by Step Guide

Starting a Car With Jumper Cables - A Step by Step Guide

Jump Starter

I will try to explain the procedure needed to start a car with jumper cables. The process is not that simple as it looks on the first sight. There are a few things you need to consider. If you follow this protocol, everything should go as planned.

First check if the car does not start because of the battery. If the engine cranks when you turn the key, the problem is not the battery and jump-starting will not do any good. If you determine that the battery is the problem then you will need another car with good batteries and jumper cables. Here is how the procedure goes.

Turn of the engine of the booster car. That is the car with good batteries that we will use to start the car with the empty battery. On the car that you are trying to jump-start you must turn of all the electrical equipment and turn the switch for engine starting off. Connect positive terminal (+) of both batteries with one of the jumper cables. For the positive terminal, or the plus terminal, use the red jumper cable. The positive terminal is usually slightly bigger than the negative. Never connect the batteries when the booster car is running.

Then put one end of the jumper cable (black) on the negative terminal (-) of the booster cars battery. Connect the other end of the black cable to an metal part of the other cars engine. If you cannot connect to a metal part, put it to the negative terminal of the other battery (-). You should do this only if there is no other way.

You must also make sure that jumper cables do not touch any moving parts of the engine. If you have completed all these steps, then you can start the engine of the booster car. You should then rev the engine. Now you can try to start the engine of the other car. If you are not successful after about 15 seconds, you must wait at least a minute before trying again. When you have successfully started the other cars engine, you should leave both running for 2-3 minutes. Before you disconnect the cables from the other car you should turn the heating of the rear window on. This will prevent high current jumps. After that, you can disconnect the jumper cables in reverse order of attachment: negative, negative, positive, positive.

Starting the engine with jumper cables should be used only when there is no other option. Make sure you follow the correct procedure when starting the car. If you do not, big voltage jumps can occur. These jumps can damage cars electronics.

cuisinart ice cream maker 2 quart

Wednesday, 2 November 2011

Car Starter Mod

Car Starter Mod On YouTube.





www.toddfun.com: Modified car starter "jumper box" to use a standard 12v lawn mower battery from Wal-Mart. This modification cost about . The correct battery for this jumper box costs + shipping so this was a no brainier it had to be modified. It works just as before but now has a lot more power.

Tags: IMG, 0003

neutrogena acne stress control foam wash children s bath accessories tripods for camera

Starting a Gas RC Car With A Bump-Start

Starting a Gas RC Car With A Bump-Start Video Clips.





how to..

Tags: Starting, Gas, RC, Car, With, Bump, Start, how, to, nitro, torqe, master, 12v, battey

eucalyptus chaise lounge

Tuesday, 1 November 2011

How To Push-Start a Car With a Dead Battery

How To Push-Start a Car With a Dead Battery On YouTube.





Learn how to push-start your car with this short tutorial.

Keywords: hothowtos, push, start, car, dead, battery, transportation, safety, emergencies, transmission, vehicle

Water Bottle Label Template Free